Power Surfboard 110cc JET Surfing Board Full Carbon 20kg Surfboard Jetting Surfing Board Carbon Fiber Material

Description

Shipping way and Esitmate shipping time.

United States:
By sea, 40 days, Trackable, UPS tracking.
Air parcel 12 days, Trackable, SF Airline.

Russia
30-35 Days, Truck delivery, trackable.

Europe Country:
By sea, 50 days, Trackable, UPS tracking.
Air parcel, 12-15 days ,Trackable , DPD tracking

Canada:
By sea, 50 days , Truck delivery, non trackable.

Mexico:
By sea, 40-50 days. Truck delivery, non trackable.

If your country not on the list, please contact us to check details
Notification

The surfboard packing size is 202x75x31cm, weight 37.5kg.
With electricity the battery for starting motor.
The size and weight is overweight for most commercial express.
So we mostly choose to send via railway /sealine, to reduce buyer's shipping cost and end price.
Please notice this before placing order.

If you want to speed up the shipping or volunting to pay more to receive the product more quickly, please contact us.
We will help you to send DHL/UPS/ DPD or other air parcel.
Notes: Checklist for the every use:

Put the surfboard on the stand before into the water.
1.Check whether the handle throttles smoothly, and whether the protection switch plugs and pulls smoothly.

2.Check whether the intake hose is crushed and broken. The intake hose mouth cannot touch the water surface.

3.Check whether the jet impeller is wrapped by foreign matter, whether the cooling pipe is connected to the spray pump firmly and if there is any breakage.

4.Check if the exhaust pipe is unobstructed.

5.Open the engine hatch cover and check:

Open the tank cap, Check the air pipe and make sure there is no petrol in air pipe.
Check the connection of intake/ exhaust pipes, the oil pipe and the cooling water pipe, make sure they are connected well; and make sure there is no bubble in oil pipe.
Check whether the electrical circuit is short or open, and the connector is loose or falling off.
Check whether the battery is fully charged.
Check whether the spark plug cap is firmly connected.
Check that the pump is working properly.
Before riding, spray the engine and the idle bearing with oil WD-40type, once a day.

Start the engine and rev it twice. The engine is only allowed to run without water cooling for a maximum of 10 seconds; otherwise the engine would overheat and one way valve will be burnt out.

6.In any case, press the engine start button no more than 5 times in a row，otherwise you must wait for 5 minutes.
Do not ride in the water area with aquatic weeds and garbage. Do not ride in sandy waters that the water depth less than 90CM.

Warm up before riding:
Take the surfboard to the water and let the bow close to the shore supports. Start the engine and let it run 2~5 minutes, in addition check the height of cooling water spout on the right side and the operation of water pump. Then you can ride if all of the above is normal.

Immediately after each riding:
Hold the surfboard up to the shore and stand upside down. Keep the intake hose down and wait until the rest of the water from the inside of the board drains out.
Put the surfboard on the stand. Start engine, 3~4 seconds, and wait until the rest of the water from the exhaust pipe drains out.
After riding your board in salt water, wash it with freshwater including the inner space and engine, and then let the engine run for about 5 seconds. Let the inner space dry out.
Spray the whole engine thoroughly with WD-40 oil. Start engine again for 1~2 seconds before injecting proper amount WD-40 oil into carburetor inlet, to prevent internal parts from rusting.